RF-Zero-Wire: Design and Analysis of Multi-Hop Low-latency Symbol-synchronous RF Communication
Xinlei Liu, Andrey Belogaev, Jonathan Oostvogels, Bingwu Fang, Danny Hughes, Jeroen Famaey
Abstract
The latency gap between wired and wireless networks poses a challenge in the adoption of wireless technologies in latency-sensitive scenarios. The gap is especially notable in multi-hop communication typical for industrial sensor networks and robotic swarms. The main reason behind it is that commonly used wireless protocols rely on store-and-forward routing and costly overhead procedures to avoid interference. This article introduces RF-Zero-Wire, an RF-based symbol-synchronous communication protocol. Instead of relaying the whole frame per hop in a store-and-forward manner, nodes concurrently relay the frame symbol by symbol, without the need for tight time synchronization. Based on data collected in real-world experiments, we reveal that the inevitable carrier frequency offsets (CFOs) introduced by imperfect crystal oscillators cause a beating effect under concurrent symbol transmissions. This is characterized by periodic constructive and destructive interference, which significantly affects reliability. Subsequently, a thorough simulation study shows how the beating problem can be overcome with error correction codes. RF-Zero-Wire allows achieving an end-to-end latency of less than 1ms for a small 4-byte frame transmitted across 5 hops. Moreover, latency is shown to increase only by 0.16% per extra hop for 16-byte frames, which is negligible compared to the over 100% per-hop latency increase observed in store-and-forward protocols. The trade-offs between network reliability and CFO range, communication distance, node density, and achievable data rate are studied in large-scale experiments based on simulation.