Optimal Placement and Sizing of PV-Based DG Units in a Distribution Network Considering Loading Capacity

Abstract

This research paper proposes an efficient methodology for the allocation of multiple photovoltaic (PV)-based distributed generation (DG) units in the radial distribution network (RDN), while considering the loading capacity of the network. The proposed method is structured using a two-stage approach. In the first stage, the additional active power loading capacity of the network and each individual bus is determined using an iterative approach. This analysis quantifies the network's additional active loadability limits and identifies buses with high active power loading capacity, which are considered candidate nodes for the placement of DG units. Subsequently, in the second stage, the optimal locations and sizes of DG units are determined using the Monte Carlo method, with the objectives of minimizing voltage deviation and reducing active power losses in the network. The methodology is validated on the standard IEEE 33-bus RDN to determine the optimal locations and sizes of DG units. The results demonstrate that the optimal allocation of one, two, and three DG units, achieved from proposed method, reduces network active power losses by 50.37%, 58.62%, and 65.16%, respectively, and also significantly enhances the voltage profile across all buses. When the obtained results are compared with the results of several existing studies, it is found that the proposed method allows for larger DG capacities and maintains better voltage profiles throughout the RDN.

Figures (7)

• Figure 1: Flowchart of the proposed methodology
• Figure 2: Single line diagram of test network [28].
• Figure 3: Fixed load and additional loading for each individual bus.
• Figure 4: RDN voltage magnitude profiles for different DG scenarios.
• Figure 5: Improved bus voltage profiles of the RDN with one DG unit.